Chelsio Communications N210 Manual do Utilizador Página 4

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 11
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 3
Introduction
This document describes the Chelsio N210 and N110 10Gb Ethernet Adapter driver for Solaris
Release 10.
Hardware and Software Requirements
The N210/N110 driver supports the following architectures.
All Sun SPARC architectures supporting PCI*/PCI-X (133, 100, or 66Mhz) adapters.
All x86 (i386) architectures supporting PCI*/PCI-X (133, 100, or 66Mhz) adapters.
o AMD CPUs, 32-bit and 64-bit (x86/x86_64/amd64)
o Intel CPUs, 32-bit and 64-bit (x86/x86_64)
*The N210/N110 10Gb Ethernet adapter supports 3.3v PCI bus only. Running a 10Gb
adapter on a PCI (32-bit) bus is not recommended as throughput performance will be
significantly reduced by the limitations of PCI.
Hardware Installation
1. Halt and power off your system.
2. Power off all remaining peripherals attached to your system.
3. Unpack the 10Gb Ethernet adapter and place it on an anti-static surface.
4. Remove the system case cover according to the system manufacturer’s instructions.
5. Remove the PCI filler plate from the slot where you will install the 10Gb Ethernet adapter.
For maximum performance, it is highly recommended to install the adapter into a PCI-X
slot running at 133Mhz. Avoid installing more than one device per PCI segment as this
will revert the bus to 100Mhz operation.
6. Holding the 10Gb Ethernet adapter by the edges, align the edge connector with the PCI
connector on the motherboard. Apply even pressure on both edges until the card is firmly
seated. It may be necessary to remove the XFP (optics) modules prior to inserting the
adapter.
7. Secure the 10Gb Ethernet adapter with a screw, or other securing mechanism, as
described by the system manufacturer’s instructions. Replace the case cover.
8. Connect a fiber cable, multi-mode for short range (SR) optics or single-mode for long
range (LR) optics, to the 10Gb Ethernet adapter.
Chelsio N210/N110 Installation and User Guide for Solaris Release 10, April 2005. 1
Vista de página 3
1 2 3 4 5 6 7 8 9 10 11

Comentários a estes Manuais

Sem comentários