Chelsio Communications Chelsio T5 Guia do Utilizador descarregar pdf (Página 124)

100

101

Chapter VII. iSCSI PDU Offload Target

Chelsio T5/T4 Unified Wire For Linux Page 124

Auth_CHAP_Policy=Mutual, the Chelsio iSCSI target will accept a relevant initiator if it does

a) no CHAP or

b) CHAP Mutual

With AuthMethod=None, regardless the setting of the key Auth_CHAP_Policy, the Chelsio iSCSI

target will only accept a relevant initiator if it does no CHAP.

With AuthMethod=CHAP, CHAP is enforced on the target:

i. Auth_CHAP_Policy=Oneway, the iSCSI target will accept a relevant initiator only if it does

a) CHAP Oneway or

b) CHAP Mutual

ii. Auth_CHAP_Policy=Mutual, the iSCSI node will accept a relevant initiator only if it does

a) CHAP Mutual

4.6. Target Access Control List (ACL) Configuration

The Chelsio iSCSI target supports iSCSI initiator authorization via an Access Control List (ACL).

ACL configuration is supported on a per-target basis. The creation of an ACL for a target

establishes:

Which iSCSI initiators are allowed to access it

The type of the access: read-write or read-only

Possible SCSI layer associations of LUNs with the initiator

More than one initiator can be allowed to access a target and each initiator‟s access rights can

be independently configured.

The format for ACL rule is as follows:

ACL=[iname=<initiator name>][;<sip=<source ip addresses>]

[;dip=<destination ip addresses>][;lun=<lun_list>:<permissions>]

target:

TargetName=iqn.2006-02.com.chelsio.diskarray.san1

TargetDevice=/dev/sda

[email protected]:3260

# initiator “iqn.2006-02.com.chelsio.san1” is allowed

# full read-write access to this target

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 459 460

Comentários a estes Manuais

Sem comentários

Chelsio Communications Chelsio T5 Guia do Utilizador Página 124

Comentários a estes Manuais

Manuais e produtos relacionados com Software Chelsio Communications Chelsio T5