Chelsio Communications Chelsio T5 Guia do Utilizador descarregar pdf (Página 171)

100

101

Chapter X. FCoE PDU Offload Target

Chelsio T5/T4 Unified Wire For Linux Page 171

Here is a sample config file for two targets each having two LUNs. Here, Logical Volumes are

exposed as LUNs. Target’s WWPN needs to be specified under TARGET_DRIVER. Initiator’s

WWPN needs to be specified under GROUP.

3.4. Configuring Persistent Target

chfcoe service is required to configure persistent target and will be installed during Unified Wire

installation. Please follow procedure mentioned below:

i. Based on your setup, create an SCST target configuration file and name it scst.conf

ii. Place the configuration file created in the previous step, scst.conf, under /etc/chelsio-fcoe/

directory.

iii. If any handler other than scst_vdisk is used in SCST configuration, please add module load

entry for the same under chfcoe_start() section of /etc/init.d/chfcoe file.

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 459 460

Comentários a estes Manuais

Sem comentários

Chelsio Communications Chelsio T5 Guia do Utilizador Página 171

Comentários a estes Manuais

Manuais e produtos relacionados com Software Chelsio Communications Chelsio T5