Chelsio Communications Chelsio T5 Guia do Utilizador descarregar pdf (Página 172)

100

101

Chapter X. FCoE PDU Offload Target

Chelsio T5/T4 Unified Wire For Linux Page 172

iv. Configure Chelsio interfaces (used for FCoE traffic) to come up with minimum MTU 2180

(recommended) during boot.

v. Configure FCoE target mode of operation (FCF or VN2VN) by editing

/etc/modprobe.d/chfcoe.conf

vi. By default the chfcoe service will be in disabled state. Enable it using the following

command:

[root@host]# chkconfig chfcoe on

To determine the run levels on which the service is enabled, run the following command:

[root@host]# chkconfig --list chfcoe

chfcoe 0:off 1:off 2:on 3:on 4:on 5:on 6:off

3.5. Verifying initiators connected to the target

Once connected to the target, initiators will be able to access the LUNs configured on the target.

Execute the following command to list the initiators which are connected to the target:

[root@host] # scstadmin –list_session

1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 459 460

Comentários a estes Manuais

Sem comentários

Chelsio Communications Chelsio T5 Guia do Utilizador Página 172

Comentários a estes Manuais

Manuais e produtos relacionados com Software Chelsio Communications Chelsio T5